Used to cut, trim or bevel any surface without having to change bits; just change bit height. Comes in 3 different cutting angles. Must be used with router table fence or straight edge.

V-Groove Bits will plunge cut a 90 V-groove. Used for cutting veins in door and drawer panels, chamfering edges, sign carving, and lettering. Also you can order the bearing and stop collar for template routing.

1-1/2" Face Clamp!

Depth Stop Collar for the 31PC (3-In-1 Pocket Cutter).

2-1/2" Face Clamp.

3" Driver for Pocket Hole Screws.

6" Driver for pocket hole screws.

These bits are used for fluting, veining, reeding, grooving or anywhere a round bottom is desired in all types of architectural millwork. Will plunge cut into softwoods, hardwoods, and composition materials.

Cuts entry hole and slot for mounting pictures, plaques, clocks, or small cabinets. T-slot will accept the head of a screw or nail. Items will hang flush to the wall without additional hardware. Route the slot horizontally. This will allow you to adjust...

Cuts entry hole and slot for mounting pictures, plaques, clocks, or small cabinets. T-slot will accept the head of a screw or nail. Items will hang flush to the wall without additional hardware. Route the slot horizontally. This will allow you to adjust...

Cuts entry hole and slot for mounting pictures, plaques, clocks, or small cabinets. T-slot will accept the head of a screw or nail. Items will hang flush to the wall without additional hardware. Route the slot horizontally. This will allow you to adjust...