3" Driver for Pocket Hole Screws.

6" Driver for pocket hole screws.

These bits are used for fluting, veining, reeding, grooving or anywhere a round bottom is desired in all types of architectural millwork. Will plunge cut into softwoods, hardwoods, and composition materials.

Cuts entry hole and slot for mounting pictures, plaques, clocks, or small cabinets. T-slot will accept the head of a screw or nail. Items will hang flush to the wall without additional hardware. Route the slot horizontally. This will allow you to adjust...

Cuts entry hole and slot for mounting pictures, plaques, clocks, or small cabinets. T-slot will accept the head of a screw or nail. Items will hang flush to the wall without additional hardware. Route the slot horizontally. This will allow you to adjust...

Cuts entry hole and slot for mounting pictures, plaques, clocks, or small cabinets. T-slot will accept the head of a screw or nail. Items will hang flush to the wall without additional hardware. Route the slot horizontally. This will allow you to adjust...

You can expect a smooth cut with our Compound Miter Blades. The -5 hook eases the blade through the wood while the high tooth count gives you that smooth result. Our 12" Compound Miter has 10 more teeth than most blades-100 teeth in all. Long-Lasting...

Great for cutting opening in paneling, drywall or siding as well as for trimming formica, veneer and other laminates.Always disconnect electricity when working near electrical outlets or boxes. Be careful that the bit does not go so deep as to cut the...

This is our top finish blade. Great for producing razor-sharp, chip-free cuts on 2-sided Melamine, double-sided laminate, or even veneered plywood. Also it performs great in crosscutting in hardwoods and softwoods. Long-Lasting Coated Blades!...

The Cabinetmaker Thin Kerf Blade is another good blade! Crosscut or rip any type of wood. No need to change the blade once it's on your saw. The 18- hook angle is aggressive on rip cuts while the alternate bevel makes the cuts smooth. The thin kerf is...

You can expect a smooth cut with our 10" Compound Miter Saw Blade. The -5 hook eases the blade through the wood while the high-tooth count gives that that smooth result. Long-Lasting Coated Blades! Sommerfeld's blades are a perfect match for our line of...

Great for cutting opening in paneling, drywall or siding as well as for trimming formica, veneer and other laminates.Always disconnect electricity when working near electrical outlets or boxes. Be careful that the bit does not go so deep as to cut the...