CMT Bearing OD1-3/8", ID 3/16"  

The sale of this product is final.  No warranty or returns.  No exceptions. This bit is a replacement groove cutter for the CMT Tongue and Groove Set (800.526.11).  

The sale of this product is final.  No warranty or returns.  No exceptions. The Junior Raised Panel Set lets you make frame and panel details as small as 2-3/4" square in material as thin as 7/16". Delicate panel doors are only the beginning -...

This is one of the largest selections of molding profile bits around. We have a wide choice of different cutting lengths and compatible profiles which can be used in pairs to create your own custom molding that no one else has. Stamp your own personality...

Used to produce a finger pull on drawer face or edge. Why use a metal knob or handle? Make a wooden handle that blends into the door.

The Ogee panel cutters require less router power to operate than our traditional horizontal models. They cannot be used with templates to make arched raised panel doors. A tall fence is also needed to help support the vertical run.

The Ogee panel cutters require less router power to operate than our traditional horizontal models. They cannot be used with templates to make arched raised panel doors. A tall fence is also needed to help support the vertical run.

This is one of the largest selections of molding profile bits around. We have a wide choice of different cutting lengths and compatible profiles which can be used in pairs to create your own custom molding that no one else has. Stamp your own personality...

Finish your door edges professionally in one pass. Used for rabbeted back doors. Cutting Diam. 2" Cutting Length 1 3/16" Overall Length 2 3/4" Shank Diam. 1/2"

Now you can create a door handle with no hardware. This bit machines in one pass a finger pull profile that visually thins the door edge also. Can also be used for table edges.

Our slot cutters have many uses. These slot cutters are 1-7/8" in diameter. Cutters are interchangeable and can be combined to give you a wide variety of cuts. Make sure cutters are put on the arbor in the correct cutting direction and always use spacers...

Used to produce a finger pull on drawer face or edge. Why use a metal knob or handle? Make a wooden handle that blends into the door.