The Easy Mark drilling jig will help you align and drill the hardware mounting holes for knobs and handles quickly, precisely and with absolute repeatability. And, when you finish, all handles and knobs will be in perfect alignment with one another...a sight to behold!
If you're still measuring, marking and drilling large numbers of mounting holes without the aid of a device like this, you're wasting a lot of valuable time.
Here's how it works:
Rest the raised ledge on the back side of the Easy Mark on the top edge of the drawer front.
Slide the horizontal stop all the way to the right and center the device on the drawer front, using the left and right half-scales as indicators.
Slide the stop to the left until makes contact with the right side of the drawer front and tighten.
Adjust drill bushings (3" to 8" on-center) to match hardware mounting hole(s) and tighten.
Loosen the locking knob on the drill bushing block...slide it vertically to your desired position...and re-tighten the locking knob.
Use a 3/16" twist drill bit in the applicable hardened busings to bore mounting holes.
Move the Easy Mark to the next drawer and repeat the process.
Item # EZM